SandW
10-12-2006, 02:11 PM
I took the seat out and repaired the rear frame member that was broken. Now it doesn't sag to the floor when you sit in it. The support iss a hollow pipe welded to part of the seat cushion support. I tapped the side of the seat and inserted long screws to hold it in place rather than trying to weld around the fabric or remove the apolstry.
What I couldn't figure out was why the rear lift feature was not fully working. It's not the switch because when I press "up" the rear left goes up leaving the rear right all the way down. Well, I guess it could be the switch but would think if it went bad it wouldn't go up on either side---do you know? It's as if the motor-to-bracket link on that side is broken or something? I couldn't see any defects with it. Anyone have this happen and/or fix it?
also, FOR SALE:
1996 300ZX 2+2 NA, black
What I couldn't figure out was why the rear lift feature was not fully working. It's not the switch because when I press "up" the rear left goes up leaving the rear right all the way down. Well, I guess it could be the switch but would think if it went bad it wouldn't go up on either side---do you know? It's as if the motor-to-bracket link on that side is broken or something? I couldn't see any defects with it. Anyone have this happen and/or fix it?
also, FOR SALE:
1996 300ZX 2+2 NA, black